Products Category
WD-TXT/24V
Product Description
|
Name |
Type |
Rated operating voltage（Un） |
Maximum continuous operating voltage（Uc） |
Rated load current（IL） |
Nominal discharge current（ln）（8/20μs） |
Maximum discharge current（nax）（8/20μs） |
Voltage protection levelUp） |
Transmission speed（Vs） |
Insertion loss（Ae） |
|
5V rail type signal lightning arrester |
TL-TX/5 |
5V |
8V |
1A |
5Ka |
10Ka |
≤13V |
10M |
≤0.3dB |
|
12V rail type signal lightning arrester |
TL-TX/12 |
12V |
15V |
1A |
5Ka |
10Ka |
≤25V |
10M |
≤0.3dB |
|
24V rail type signal lightning arrester |
TL-TX/24 |
24V |
30V |
1A |
5Ka |
10Ka |
≤60V |
10M |
≤0.3dB |
|
4-20ma rail type signal lightning arrester |
TL-TX/4-20 |
24V |
30V |
1A |
5Ka |
10Ka |
≤60V |
10M |
≤0.3dB |
|
36V rail type signal lightning arrester |
TL-TX/36 |
36V |
82V |
1A |
5Ka |
10Ka |
≤100V |
10M |
≤0.3dB |
|
110V rail type signal lightning arrester |
TL-TX/110 |
110V |
180V |
1A |
5Ka |
10Ka |
≤230V |
10M |
≤0.3dB |
|
12V rail type power lightning arrester |
TL-DY/12 |
12V |
18V |
2A |
5Ka |
10Ka |
≤60V |
- |
- |
|
24V rail type power lightning arrester |
TL-DY/24 |
24V |
47V |
2A |
5Ka |
10Ka |
≤90V |
- |
- |
|
48V rail type power lightning arrester |
TL-DY/48 |
48V |
82V |
1A |
5Ka |
10Ka |
≤130V |
- |
- |
|
220V rail type power lightning arrester |
TL-DY/220 |
220V |
470V |
1A |
5Ka |
10Ka |
≤900V |
- |
- |
Dimension specification of guide rail lightning arrester
Installation diagram of guide rail lightning arrester
Installation Instructions
This product is connected in series.
Please select a product with the same interface type as the protected device.
A-A/B-B of this product; (L/+) - (L/+)/(N/-) - (N/-) channels are one-to-one corresponding, and cross wiring is prohibited.
The "IN" of the lightning arrester is the input terminal connected to the "surge terminal" line, and the "OUT" is the output "equipment terminal" connected to the protected equipment.
The PE line of the lightning arrester must be reliably connected with the ground wire of the lightning protection system, and the connecting line is required to be short and thick.
The lightning arrester shall be tested regularly during its use. In case of failure, it shall be repaired or replaced in time to ensure the safety of the equipment